Belt Conveyor Drives

The driven roller should be fitted on the outfeed end of the belt conveyors.  The load being pulled by the drive is equally important. Similarly the top side of the belt should be in tension and furthermore should only be used in a single direction.

Center drives are generally ideal for long conveyors where additional take up is required in addition to conveyors which have to travel in both directions. Additionally the drive position of the belt at the top of the conveyor is always in tension.

Fitting the electric motor and gearbox internally within the end roller with the purpose of the drum motor drive providing a reliable clean line finish to the conveyor. The conveyor design becomes more important as they can be more difficult to maintain. Thus allowing them to be more energy efficient than conventional motors. Together with less external moving parts. With this in mind the reliability and quick service is second to none and often the drive of choice.

These are usually used alongside a fixed shaft drive pulley. Generally Electric geared motors power conveyors most often. With either a hollow bore for direct shaft mounting, or with an output shaft together with chain and sprockets. Alternatively timing belts would be used. Geared motors are normally easier to change for regular maintenance. Additionally they can be split into component form. For example gearbox and electric motor. Furthermore geared motors are widely available and cheaper.